INSTALLATION / SETUP
Plug the EVO SP8 into a mains outlet using the mains power lead included in
the box. For more information on how to connect your device to your host
interface, please read the ‘Clocking Conguration’
section of this Manual.
The rst time powering on EVO SP8, you will be asked to follow the setup
procedure, allowing you to customise EVO SP8’s settings to your liking.
Firstly, you can adjust and set the brightness of all of EVO SP8’s hardware
LEDs, including the LED Ring, to suit your studio environment. Use the Control
Wheel to adjust the slider and then click the Control Wheel to save your
settings and then hit ‘Next’
INSTALLATION / SETUP
Initial Setup
To Next Page
Loading...