HARDWARE
EVO SP8 also provides you with eight dedicated Line Level Outputs, which can
be found at the rear of the unit. These can either be fed from the 8 onboard EVO
Preamps (Analogue) or from the ADAT inputs (Digital) by adjusting the Output
Source in the Setup Menu.
When set to Analogue, Preamp 1 will feed into Output 1, Preamp 2 will feed into
Output 2 and so on…
When set to Digital, ADAT Input 1 will play out of Line Output 1, ADAT Input 2 to
Line Output 2 and so on…
After the listening period, all EVO units will show the status of their 8 channels.
If any channels have failed on any device, this channel will show in a red circle
allowing you to check your mic connections on that particular device and then
try Smartgain again.
Line Outputs
To Next Page
Loading...