ä
The command sequence is as follows:
Sending the SIS sequence :
l A card is moved from the feeder to the contact station, and stops underneath it.
l The card is pushed upwards to make contact with the station.
l The printer connects the contact station to the DB-9 connector.
l The chip is programmed via the computer’s serial interface and the external coupler.
Refer to the Evolis printer Programming Guide for further details on programming smartcards.
The Evolis product catalogue has printers equipped with a chip contact station and a built-in encoder. Depending on the model, these
encoders connect to the PC via an RS-232 interface (DB-9 socket) or a USB interface.
C
53
To Next Page
Loading...
