K1 MICRO BEAD FILTER SPECIFICATIONS
AIR BLOWER SIZE
The maximum working pressure of all K1 Micro Bead Filters is 2.5 Bar.
K1 MICRO BEAD 20 FILTER (20”) = 200W Air Blower
K1 MICRO BEAD 24 FILTER (24”) = 200W Air Blower
K1 MICRO BEAD 30 FILTER (30”) = 300W Air Blower
K1 MICRO BEAD 36 FILTER (36”) = 300W Air Blower
On the pipe run between the MPV and the Air Blower
there is a 1½” ball valve fitted.
The ball valve handle must always be closed when
the circulating pump is switched on. This indicates
that the ball valve is CLOSED.
This is designed to prevent water flowing back
into the air blower.
Only open the ball valve when the pump is
switched off and before operating the air blower.
FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY INVALIDATE THE WARRANTY.
5
MODEL NO. K1MICROBEAD20 K1MICROBEAD24 K1MICROBEAD30 K1MICROBEAD36
Diameter 20” 24” 30” 36”
Volume of
K1 Micro
Media
50 Litres 100 Litres 150 Litres 250 Litres
Multi-Port
Valve size
1½” 2” 2” 2”
Maximum
pond size
4,000 UK Gallons 8,000 UK Gallons 12,000 UK Gallons 20,000 UK Gallons
18,000 Litres 36,000 Litres 54,500 Litres 91,000 Litres
4,800 US Gallons 9,600 US Gallons 14,500 US Gallons 24,000 US Gallons
Figure 1a.
Figure 1b
BALL VALVE FITTED
BELOW THE AIR BLOWER
IMPORTANT
PLEASE READ
To Next Page
Loading...
