Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by
inserting pointed objects through openings
in the machines casings etc. The machines air
vents should be cleaned using compressed
dry air.
Excessive sparking may indicate the presence
of dirt in the motor or worn out carbon
brushes. If this is suspected have the machine
serviced and the brushes replaced by a
qualified technician.
CHECKING/REPLACING THE CARBON
BRUSHES.
WARNING: Disconnect the machine from the
power supply before attempting to check or
replace the Carbon Brushes.
Note: Replace both carbon brushes if
either has less than 6mm. length of carbon
remaining, or if the spring or wire is damaged
or burned.
To remove the brushes:
• Unscrew the plastic caps found at the back
of the motor. Be careful as the caps are spring-
loaded.
• Withdraw the brushes with their springs.
• If replacement is necessary renew the brushes
and replace the caps.
Note: Used but serviceable brushes can be
replaced, but only as long as they are returned
to the same position, and inserted the same
way round, as they were removed from the
machine.
• Run new brushes without load for
approximately 5 minutes. This will help the
bedding-in process.
(6.4) ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
To Next Page
Loading...
