EWM PICOTIG 180 AC/DC User Manual

EWM HIGHTEC WELDING GmbH
Dr. Günter - Henle - Straße 8; D-56271 Mündersbach
Phone: +49 (0)2680.181-0; Fax: +49 (0)2680.181-244
Internet:
www.ewm.de ; E-mail: info@ewm.de
Operating instructions
GB
Welding machines for
TIG and MMA welding
These operating instructions must be read before commissioning.
Failure to do so may be dangerous.
Machine may only be operated by personnel familiar with the appropriate safety
regulations.
The machines bear the conformity mark and thus comply with the
• EC Low Voltage Guideline (73/23/EEC)
• EC EMV Directive (89/336/EEC)
In compliance with IEC 60974, EN 60974, VDE 0544 the machines can be used in
environments with an increased electrical hazard.
© 2008 Subject to alteration! Art. Nr.: 099-002004-EWM01 Stand: 15.02.2008

EWM PICOTIG 180 AC/DC Specifications

General

Input Voltage	230 V
Output Current Range (TIG AC/DC)	5 - 180 A
Welding Process	TIG AC/DC, MMA
Input Current	16 A
Protection Class	IP23
Insulation Class	F
Welding Current Range (MMA)	10 A - 150 A
Power Supply Voltage	230 V