+1.317.845.5710
+5255.56080817
+44.1438.310163
USA (Corporate Headquarters)
Mexico
Europe/Middle East/Asia
27
IMPORTANT NOTE
Many IP camera settings that are not available in the exacqVision software can be accessed through the camera’s web
page. To view an IP camera’s web page, click the hyperlink in the IP Address field. If you don’t see a hyperlink beside the
IP Address field, it could be for one of two reasons:
A. You are not logged in to the operating system with administrative privileges. You must log in to operating system
account with administrative privileges to access the hyperlink.
B. Your client computer is not located on the same IP subnet as the IP camera. This could occur if you are using the
client from a home computer to access a server at your office, for example. This restriction should cause few
issues because camera website settings are typically changed only during initial configuration.
To Next Page
Loading...