17
exactmeters.com
CYANURIC ACID
FILL, DIP, READ
5
SHAKE BOTTLE & ADD DROPS
Tilt the meter to discard about 0.2mL water to leave
room for liquid reagent. Shake the bottle of eXact
®
Reagent CY to mix the suspension in the bottle. Refer
to images below for correct amount of drops of eXact
®
Reagent CY to add to the sample cell. Keep reagent
bottle vertical while adding drops.
S/N ≤1310
Part #
481652-II
5 Drops
S/N ≥1311
Part #
481652-III
8 Drops
7
CAP & PRESS READ
Place the cell cover onto the sample cell. Press
to initiate a 20 second countdown. Place thumb or
fi nger over cap, and mix the sample by turning the
meter upside-down repetitively during the 20 second
countdown. When timer displays 1, place the meter on
a fl at surface (upright). The display will automatically
start to count up for 60 seconds.
TIP
For water temperatures above 95°F/35°C (hot tubs), Press READ
when the timer displays “10” during the countdown.
8
CAP CELL AND READ RESULTS
READ result displayed as Cyanuric Acid. This result is
automatically stored in the CY(6) menu. After testing
is complete, rinse the sample cell immediately and
clean with brush.
To Next Page
Loading...
