Excell 150S User Manual

13
040112XX
ZSME400000005
EXCELL PRECISION CO., LTD
Item
Function
Setting value
Default
Parameter
Description
FNC-13
Turn-on zero setting
0
Disable
0
1
Enable
FNC-14
Stand-by mode setting
0
Disable all the functions under
stand-by mode
0
1
Only turn off display but not
disable other functions under
stand-by mode
FNC-15
Zero function record
setting
0
Zero point record not saved into
EEPROM
0
1
Zero point record saved into
EEPROM
FNC-16
Internal calibration
password setting
0000
No password
0000
0001
Password is set
FNC-17
Turn on/off watchdog
1
Turn on watchdog
1
0
Turn off watchdog
2-4 Set internal calibration password (FNC-16)
The default value of FNC-16 is 0000, which means internal calibration without password. To
set a password, enter 4-digit numbers (other than 0001, 0000) and press confirm key to
complete. If password is set to 0001, error message “UN.VALI” will appear.
If password has been set, FNC-16 will display 0001. To change password, it must enter
the previously set password first. If entered password is wrong, it displays “PW ERR”. If entered
password is correct, it displays “NEW PW” and then enters 4-digit numbers (other than 0001) for
new password or enters 0000 to remove password. If password is forgotten, it must reset to
factory setting.

Excell 150S Specifications

General

Brand	Excell
Model	150S
Category	Controller
Language	English