EXCELL PRECISION CO., LTD
Chapter 2 General Function Guide
2-1 Function Setup and Operation Procedures
Turn the calibration switch to “ON”
Press not release,
then press key
after the power is turned on
Reset all parameters
back to default
Turn the power on then turn the
calibration switch to “ON” then
press and hold the
and keys during the
self-testing sequence
Reset general function
parameters back to
default
Turn the power on and
press and keys
during self-testing sequence
Clear zero point
compensation and tare
value
Turn the power on and
press and keys
during self-testing sequence, and
then press key
Clear setpoint parameter
setting
Turn the power on and
press and keys
during self-testing sequence, and
then press two times
Value of zero point
voltage(mV / V)
Turn the power on and
Press and ,then
press key three times
Value of Span voltage
(mV / V)
Turn the power on and
Press and , then
Press key
Turn the power on and
press and keys
during self-testing sequence
To Next Page
Loading...
Need help?
General
