Exerpeutic 1020 - Page 18

17
TROUBLESHOOTING GUIDE
1.
Apply silicone lubricant.
2. Adjust belt tension.
Adjust belt tension.
1.
Put the power plug into the
electrical wall outlet.
2. Install the safety tether key.
3. Reset or have an electrician
replace the breaker in home.
4. Wait five minutes and then
press the switch back in.
Center the belt.
Problem
Treadmill will not
start.
Belt slips.
Belt is off
centered.
Potential Causes
1.
Not plugged in.
2. Safety tether key not
connected.
3. House circuit breaker
tripped.
4. Treadmill circuit breaker
tripped.
Belt not tight enough.
1.
Not enough
lubricati
on
applied onto the running
deck.
2. Belt is too tight.
Running belt tension not
even across the rear roller.
Corrections
B
elt hesitates
When stepped
on.