Exibel BPX1000 - Operating instructions; Charging the Built-in Battery; Switching Speaker On and Off; Connecting External Bluetooth Device

4
English
Operating instructions
Power sources: Integrated internal battery or mains powered.
Charging the built-in battery
Plug thespeaker’s mains lead into awall socket to charge. Charge thebattery for
aminimum of 48 hours before initialuse.
Charge indicator:
• Red: Thebattery is almostflat. Charge thebattery.
• Flashinggreen: Charging in progress.
• Solidgreen: Battery fully charged.
Switching on/off
• Turn thespeaker on by turning the [ Music volume/On-Off ] (3) knob clockwise.
Thespeaker automatically starts in Bluetooth mode making it immediately
detectable for other Bluetooth devices. TheBluetooth function turns of if no
Bluetooth devices are paired within thefirst 2min. Ifthetime has expired, press
the [ PAIR ] button to make thespeaker detectable again for other Bluetooth devices.
• Turn thespeaker off by turning the [ Music volume/On-Off ] (3) knob fully counter-
clockwise.
Connecting an external Bluetooth device
1. Switch thespeakeron.
2. Theblue Bluetooth indicator will begin flashing quickly which indicates that
thespeaker is ready to be paired with other Bluetooth devices.
3. Activate Bluetooth on thedevice to be paired with thespeaker.
4. Thespeaker will appear on your device as BPX1000, select it and pair it with your
device. Oncecontact has been established, theBluetooth indicator will begin
flashing slowly.
5. Start playback on your device. Setthedesired volume levels both on theexternal
device and thespeaker. Thevolume on theexternal device must be set to max
in order for you to achieve sufficient volume and for thespeaker’s LED effect
lighting to function effectively. Turnthevolume on theexternal device up tomax.
Otherplayback settings should be controlled from theexternal device.
6. Making thespeaker detectable for other Bluetooth devices:
- Turn off Bluetooth on thelast connected device.
- Activate Bluetooth on thenew device to be paired.
- Press thespeaker’s [ PAIR ] button.
- TheBluetooth indicator (2) will begin flashing quickly, meaning that it is again
detectable for other Bluetooth devices.
Note: Ifyou are prompted to enter aPIN code on your device, you should enter 0000
(four zeroes). Certain devices may also require you to approve theconnection.