- 6 -
1.5.6 Maximum mowing results and safety can only be achieved if the mower is
properly maintained and operated correctly.
1.5.7 Check all bolts frequently to maintain proper tightness.
1.5.8 Keep all guards, shields and all safety devices in place and in safe working
condition.
1.5.9 Frequently check for worn or damaged components that could create a hazard.
1.5.10 All replacement parts must be the same as or equivalent to the parts supplied as
original equipment.
1.6 RIDING ATTACHMENTS
Use only Exmark riding attachments. The use of other than Exmark riding attachments
may create a hazardous condition resulting in injury.
1.7 SAFETY SIGNS
1.7.1 Keep all safety signs legible. Remove all grease, dirt and debris from safety signs
and instructional labels.
1.7.2 Safety signs must be replaced if they are missing or illegible.
1.7.3 When new components are installed, be sure that current safety signs are affixed
to the replaced components.
1.7.4 New safety signs may be obtained from your authorized Exmark equipment dealer
or distributor or from Exmark Mfg. Co. Inc.
1.7.5 Safety signs can be affixed by peeling off the backing to expose the adhesive
surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.
1.7.6 Familiarize yourself with the following safety signs and instruction labels. They are
critical to the safe operation of your Exmark commercial mower.
PART NO. 1-303518
LOCATION: Transmission Shifter Plate
PART NO. 1-513746
LOCATION: Engine Blower Housing
Next to Muffler
PART NO. 1-303508
LOCATION: Right Rear Corner
of Deck
PART NO. 1-303517
LOCATION: Left Side, Rear Surface Engine Deck
PART NO. 1-323427
LOCATION: 32” & 36” Decks Under Belt Shield
PART NO. 1-403170
LOCATION: 48” Decks Under Belt Shield
To Next Page
Loading...
