Exmark Quest Lawn Mower User Manual (English)

Questions and Answers:

D
Diane CaldwellAug 12, 2025
Why won't my Exmark Quest Lawn Mower engine start?
- M
  matthewmarquezAug 12, 2025
  If your Exmark Lawn Mower engine won't start, starts hard, or fails to keep running, several factors could be the cause. First, check if the fuel tank is empty and fill it if needed. Ensure the choke is on. A dirty air cleaner can also be the culprit, so clean or replace it. Inspect the spark plug wire(s) to ensure they are properly connected. Replace any pitted, fouled, or incorrectly gapped spark plug(s). Other potential issues include a dirty fuel filter, dirt, water, or stale fuel in the fuel system (in which case you should contact an Authorized Service Dealer), incorrect fuel in the fuel tank (drain and replace with the proper type), or a low oil level in the crankcase (add oil to the crankcase).
A
Andrew KellyAug 16, 2025
What to do if my Exmark Lawn Mower starter does not crank?
- N
  Nicholas WoodsAug 16, 2025
  If the starter on your Exmark Lawn Mower doesn't crank, there are several things you can check: * Ensure the blade control switch is disengaged. * Make sure the motion control levers are in the park position. * Confirm that the operator is seated. * Check if the battery is dead and charge if necessary. * Inspect electrical connections for corrosion or looseness. * See if a fuse is blown and replace it if needed. If these steps don't resolve the issue, a relay or switch might be damaged, and you should contact an Authorized Service Dealer.
S
Steven MaddenAug 20, 2025
How to fix an Exmark Quest Lawn Mower engine that overheats?
- J
  Janet AdamsAug 20, 2025
  If your Exmark Lawn Mower engine overheats, it could be due to several reasons. First, the engine load might be excessive, so reduce the ground speed. Check the oil level in the crankcase and add oil if it's low. Make sure the cooling fins and air passages under the engine blower housing are free from obstructions. A dirty air cleaner can also cause overheating, so clean or replace the air cleaner element. If there's dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer.
T
Thomas GregoryAug 23, 2025
Why does my Exmark Lawn Mower engine lose power?
- A
  Amber RochaAug 23, 2025
  If your Exmark Lawn Mower engine loses power, several factors could be responsible. An excessive engine load may be the cause, so reduce the ground speed. Check the air cleaner and clean or replace it if it's dirty. Ensure the oil level in the crankcase is adequate, and add oil if it's low. Clear any obstructions from the cooling fins and air passages for the engine. Replace the spark plug(s) if it is pitted, fouled, or the gap is incorrect. Also, check that the vent hole in the fuel cap is open. Replace the fuel filter if it's dirty. If the issue persists, there may be dirt, water, or stale fuel in the fuel system, or incorrect fuel in the fuel tank. In those cases, contact an Authorized Service Dealer or drain the tank and replace the fuel with the proper type.
M
Michael MorrisAug 27, 2025
How to troubleshoot uneven cutting height on Exmark Quest Lawn Mower?
- A
  Amanda JohnsonAug 27, 2025
  To troubleshoot uneven cutting height on your Exmark Lawn Mower, start by checking if the blade(s) are sharp and sharpen them if necessary. Replace the cutting blade(s) if they are bent. Ensure that the blade is not loose, and tighten the blade mounting bolt. Level the mower deck from side-to-side and front-to-rear. Adjust the anti-scalp wheel height. Clean the underside of the mower. Adjust the tire pressure in drive tires. If the blade spindle is bent, contact an Authorized Service Dealer.
B
barrlindaAug 31, 2025
What causes abnormal vibration in Exmark Lawn Mower?
- M
  Michael AndersonAug 31, 2025
  Abnormal vibration in your Exmark Lawn Mower can stem from several issues. Start by tightening the engine mounting bolts if they are loose. Check for any loose engine pulley, idler pulley, or blade pulley and tighten the appropriate pulley. If the engine pulley is damaged or the blade spindle is bent, contact an Authorized Service Dealer. Replace the cutting blade(s) if they are bent or unbalanced. Ensure the blade is not loose, and tighten the blade mounting bolt.

Exmark Quest Lawn Mower Specifications

General

Brand	Exmark
Model	Quest Lawn Mower
Category	Lawn Mower
Language	English

Summary

Introduction

Model and Serial Number Location

Identifies where to find the model and serial numbers on the machine.

Safety

Safety Alert Symbol

Explains the meaning and importance of the safety alert symbol.

Safe Operating Practices

Provides essential safety guidelines for operating the machine.

General Operation Safety

Covers fundamental safety rules for operating the mower.

Slope Operation Safety

Details precautions for mowing on slopes to prevent accidents.

Children Safety

Highlights the risks of children around the mower and precautions.

Towing Safety

Outlines safety considerations when towing equipment.

Safe Handling of Gasoline

Provides safety instructions for handling flammable gasoline.

General Service Safety

Covers safety precautions during maintenance and service.

Exmark Riding Mower Safety

Specific safety information for Exmark riding mowers.

Safety and Instructional Decals

Explains the purpose and importance of safety decals on the machine.

Specifications

Model Numbers

Lists the available model numbers for the machine.

Systems Overview

Details various systems of the mower, including engine and electrical.

Operator Controls

Describes the function of steering, motion, and PTO controls.

Seat Specifications

Details the features and mounting of the operator's seat.

Hydrostatic Ground Drive System

Information on the hydrostatic transmission, pumps, and speeds.

Tires & Wheels Specifications

Provides details on tire sizes, ply rating, and pressure.

Cutting Deck Specifications

Covers cutting width, blade size, and spindle types.

Dimensions

Lists overall width, length, and height of the mower.

Torque Requirements

Specifies torque values for various bolts and nuts.

Product Overview

Component Identification

Identifies key components of the mower using a diagram.

Tread Width and Wheel Base

Provides measurements for tire tread width and wheel base.

Curb Weight

States the weight of the mower.

Operation

Ignition Switch Operation

Instructions on how to start and stop the engine using the ignition switch.

Blade Control Switch

Explains how to engage and disengage the mower blades.

Choke Control

Details the use of the choke for starting a cold engine.

Throttle Control

Instructions on adjusting engine speed.

Motion Control Levers

Explains how to operate the levers for forward, reverse, and stopping.

Parking Brake Lever

How to engage and disengage the parking brake.

Height-of-Cut Lever

How to adjust the cutting height of the mower deck.

Operating Instructions

General guidance and safety reminders for operating the mower.

Recommended Gasoline

Specifies the type of gasoline to use and warnings.

Fuel Tank Filling

Procedures for safely filling the fuel tank.

Starting the Engine

Step-by-step guide to starting the mower engine.

Operating the Blades

How to engage and disengage the mower blades.

Safety Interlock System

Explains the safety system preventing operation under unsafe conditions.

Driving Forward or Backward

Instructions for controlling the mower's movement.

Stopping the Machine

Steps to safely stop the mower.

Tracking Adjustment

How to adjust the mower to drive straight.

Adjusting Cutting Height

Procedures for setting the desired cutting height.

Adjusting Anti-Scalp Rollers

How to adjust rollers to prevent deck scalping.

Positioning the Seat

Guidance on adjusting the seat for comfort and control.

Seat Ride Suspension Adjustment

How to adjust the seat suspension for different operators.

Adjusting Motion Control Levers

Adjusting lever height and tilt for operator comfort.

Pushing the Machine by Hand

Steps for safely moving the mower manually.

Side Discharge Operation

Information on the mower's side discharge deflector.

Transporting the Unit

Guidelines for safely transporting the mower.

Loading the Unit

Safety precautions and procedures for loading the mower.

Operating Tips

Advice for optimal mowing performance and lawn care.

Mower Cutting Practices

Advice on cutting speed, height, and handling long grass.

Blade Maintenance

Guidance on maintaining sharp and undamaged mower blades.

Maintenance

Recommended Maintenance Schedule

A schedule outlining maintenance tasks based on service intervals.

Premaintenance Procedures

Steps to take before performing maintenance, like raising the seat.

Periodic Maintenance and Lubrication

Regular maintenance tasks including lubrication of bearings.

Engine Maintenance

Procedures for servicing the engine, including the air cleaner.

Engine Oil Servicing

How to check and change the engine oil and filter.

Fuel System Maintenance

Procedures related to maintaining the fuel system.

Electrical System Maintenance

Maintenance tasks for the mower's electrical components.

Battery Maintenance

Instructions for removing, charging, and installing the battery.

Fuse and Relay Servicing

How to check and replace fuses and relays.

Drive System Maintenance

Maintenance procedures for the drive system.

Mower Maintenance

Maintenance tasks specifically for the mower deck.

Blade Maintenance Procedures

How to inspect, sharpen, balance, and replace mower blades.

Mower Belt Maintenance

Procedures for inspecting and replacing mower belts.

Mower Deck Leveling

How to ensure the mower deck is level side-to-side and front-to-rear.

Mower Deck Removal and Installation

Steps to detach and reattach the mower deck from the tractor.

Replacing Discharge Deflector

How to replace the mower's side discharge deflector.

Cleaning the Mower Underside

How to clean the mower deck underside using water.

Storage

Cleaning and Storage Procedures

Steps for preparing the mower for long-term storage.

Troubleshooting

Engine Problems

Diagnosing and fixing engine overheating, starting, and power issues.

Drive System Problems

Troubleshooting issues with the machine not driving or vibrating.

Mowing Performance Problems

Diagnosing and fixing uneven cutting height or blades not rotating.

Schematics

Electrical Diagram - Briggs & Stratton

Wiring diagram for Briggs & Stratton engine models.

Electrical Diagram - Kohler Command

Wiring diagram for Kohler Command engine models.

Warranty Information

Consumer Warranty Details

Details of the limited consumer warranty for riding mowers.

Commercial Use Warranty

Warranty terms for commercial, institutional, or rental use.

Warranty Exclusions

Specifies what is excluded from the warranty coverage.

Obtaining Warranty Service

How to get warranty service and contact information.

Owner's Responsibilities

Operator duties for maintaining warranty coverage.

General Warranty Conditions

General terms and limitations of the warranty.

Accessories

Mid-Mount Riding Accessories

List of accessories for mid-mount riding mowers.

Out-Front Riding Accessories

List of accessories for out-front riding mowers.

Walk-Behind Accessories

List of accessories for walk-behind mowers.

Related product manuals

Exmark QUEST S Series

76 pages

Exmark QUEST 4500-339

24 pages

Exmark Quest 4500-450

56 pages

Exmark Quest QST24BE522

52 pages

Exmark Ultra Vac QDS

96 pages

Exmark QSS708GEM42200

Exmark LAZER Z E Series

76 pages

Exmark Quest Lawn Mower User Manual

Table of Contents

Questions and Answers:

Exmark Quest Lawn Mower Specifications

Summary

Introduction

Model and Serial Number Location

Safety

Safety Alert Symbol

Safe Operating Practices

General Operation Safety

Slope Operation Safety

Children Safety

Towing Safety

Safe Handling of Gasoline

General Service Safety

Exmark Riding Mower Safety

Safety and Instructional Decals

Specifications

Model Numbers

Systems Overview

Operator Controls

Seat Specifications

Hydrostatic Ground Drive System

Tires & Wheels Specifications

Cutting Deck Specifications

Dimensions

Torque Requirements

Product Overview

Component Identification

Tread Width and Wheel Base

Curb Weight

Operation

Ignition Switch Operation

Blade Control Switch

Choke Control

Throttle Control

Motion Control Levers

Parking Brake Lever

Height-of-Cut Lever

Operating Instructions

Recommended Gasoline

Fuel Tank Filling

Starting the Engine

Operating the Blades

Safety Interlock System

Driving Forward or Backward

Stopping the Machine

Tracking Adjustment

Adjusting Cutting Height

Adjusting Anti-Scalp Rollers

Positioning the Seat

Seat Ride Suspension Adjustment

Adjusting Motion Control Levers

Pushing the Machine by Hand

Side Discharge Operation

Transporting the Unit

Loading the Unit

Operating Tips

Mower Cutting Practices

Blade Maintenance

Maintenance

Recommended Maintenance Schedule

Premaintenance Procedures

Periodic Maintenance and Lubrication

Engine Maintenance

Engine Oil Servicing

Fuel System Maintenance

Electrical System Maintenance

Battery Maintenance

Fuse and Relay Servicing

Drive System Maintenance

Mower Maintenance

Blade Maintenance Procedures

Mower Belt Maintenance

Mower Deck Leveling

Mower Deck Removal and Installation

Replacing Discharge Deflector

Cleaning the Mower Underside

Storage