EXPERT GRILL Commodore - Page 27

- 25 -
“ErL”
 Insufficient or
poor pellets
 Check and remove fire pot ash
build-up, obstructions and that
it is seated properly in the
firebox.
 Ensure igniter is heating up and
positioned correctly.
 Check fans to confirm operation
and speed.
 Ensure hopper has sufficient
standard pellets.
 Press "Prime" or put a small
amount of pellets into fire pot.
Problem
Cause
Solution
Igniter does
not work
 Insufficient
air flow
 Check and remove fire pot ash
build-up, obstructions and that it is
seated properly in the firebox.
 Igniter rod
is not work
 Check to confirm igniter DOES
NOT get hot. When you check it,
DO NOT TOUCH the igniter or
the housing, you may will get
burnt.
 Check on placement of the igniter
rod to the fire pot.
 Cut off the power, remove
baseboard of hopper, ensure wire
connectors are tight.
Produces
excess
or discolored
smoke
 Excess
grease
build-up
 Check and clean the interior
grilling area.
 It is a good practice to clean and do
a controlled burn off the hidden
excess grease after each large
cooking of tasty greasy foods.
 Pellets wet
 Check and clear the hopper and
fire pot of moist pellets, replacing
them with fresh dry pellets.
 Excess
pellets
 Check and remove excess pellets in
the hopper.