30
Megacrem
Programming the coffee dosage
PROGRAMMING
i
To program the coffee doses dispensed automatically by each drink button follow the steps below:
Note:
Programming any of the options on the left-hand-side drink buttons bank (when
viewing the machine from the front) automatically sets the dispensing volumes on
all of the other drink buttons. This only applies to the left-hand-side drink buttons.
Programming other groups’s drink buttons only modifies the option selected.
Important:
Use a portafilter filled with fresh coffee for every new dose you program.
On machines not equipped with a display, press and hold the Continuous Dispensing button
for 4 seconds, all of the drink buttons lights will be turned on. On machines equipped with a display,
press and hold the Continuous Dispensing button for 8 seconds, the Continuous Dispensing button
light will flash.
Press the dispensing option that you wish to program: 1 Short Espresso, 1 Long Espresso, 2 Short
Espressos or 2 Long Espressos. The lights on the pressed button and the Continuous Dispensing
button will remain on.
The group will start dispensing coffee. When the desired volume is reached in the cup, press the
selected button again to stop dispensing. This volume setting will be saved. On machines equipped
with a display, the lights on the reprogrammed dosage buttons will remain off.
Repeat this process for all of the dispensing options that you wish to reprogram.
If you only need to reprogram one of the dispensing options, follow the steps above and program just
that option. All of the other dispensing options will remain unchanged (default settings).
To Next Page
Loading...
Need help?
General
