Express Water MODEL 6 - Installation: Tubing Connections; Tubing Preparation and Port Connections

8
INSTALLATION
CAUTION
•Thecutsonthetubingmustbestraightandsmoothwithoutanybrokenedgesaectingthesealing.
• Make sure that the tubing is not deformed after being cut and inspect the O-shaped gasket for any damages so that no water
leakage occurs.
5) Installation of the pure water outlet tubing
A. Use a tube cutter to cut an appropriate length
of the matching white ¼” tubing.
B. Insert one end of the tubing into the pure
water outlet port of the system. After the tubing
is inserted in place, insert the ¼” lock clip in the
position of the quick-release connector slot.
C. Connect the other end of the tubing to the
faucet through the quick-release connector.
4) Installation of the waste water tubing
A. Use a tube cutter to cut an appropriate length
of the matching red ¼" tubing.
B. Insert one end of the tubing into the waste
water outlet of the system. After the tubing is
inserted in place, insert the ¼” lock clip in the
position of the quick-release connector slot.
C. Connect the other end of the tubing to the
drain saddle and secure connection.
3) Installation of the inlet water tubing
A.Cutaproperlengthof⅜”tubingwithoneend
connected to the 3-way connector valve joint.
B. Insert the other end of the tubing into the
waterinlet(IN)port,andtheninsertthe⅜”lock
clip at the slot of the quick connect connector.
NOTE: Make sure to insert the tubing as far as
possible for a secure connection.
2) Remove plugs from port of system
A.Useyourngertopressdownonthecollet
(loose ring around plug).
B. Use your other hand to pull out the plug from
pure water port.
C. Repeat step A and B to pull out balance plugs
from inlet water port and waste water port.
3.6 Tubing Installation
1) Tubing cutting
Cut tubing with proper length, and the incision
shouldbeush,asshownhere:
#1 Press
down on the
collet
#2 Pull out the plug
Water inlet port
⅜”tubing
Lockclip
⅜”tubingofan
appropriate length
Connect to
3-way connector
Waste water port
Pure water port
¼” tubing (red)
¼” lock clip
¼” tubing of an
appropriate length
¼” tubing of an
appropriate length
Note: See 3.7 for faucet connection
¼” tubing (white)
¼” lock clip
Drain saddle (see p.8)