Extech Instruments EA80 User Guide

EA80-en-GB_v3.3 09/15
7
Manual Datalogging
Storing readings
Press the "MEM" button. The LCD will display "M" and the
memory address number. The total memory size is 99
readings.
Viewing readings
Press the "READ" button to enter READ mode. The LCD will
display "R" and the memory address number.
Press " " or " " to scroll through the stored readings.
Press "  " enter to exit this mode.
Deleting stored data
Press the “SET” button three times. The LCD will display “CLr” and the meter will enter the Clear
Memory mode.
Press “” to clear the all manually stored readings.
To abort, press the “SET” button twice and then press the “” button to exit the Clear Memory
mode.
Auto Datalogging
Setting interval time
Press “SET” two times. The “INTV” mark will appear and the meter will enter the Interval Time
setting mode.
Use the “” or “” button to select the desired interval time from 1 to 255 seconds.
Press the “” button to store the value and to exit the mode.
Auto Datalogging mode
Press and hold “MEM” for two seconds (3 beeps), the LCD will display the “  ” icon and the
memory location.
The “M” will flash each time a recording is made.
The maximum memory capacity is 16,200 recordings that can be divided into 99 sets.
Press the “” button to exit this mode and to stop recording.
Deleting Logged Data
Press “SET” four times, the “CLr” and “  ” mark will be displayed.
Press the “” button to clear the automatically stored data and to exit this mode.
To abort, press the “SET” button again then press the “” button to exit.
SET MAX
MIN
ALM
R
M
Err
INTV
Err
CO2
ppm
ppm
%RH
d-h
CO 2
DEW
WET
°C°F
ppm
CO 2
m:s
8888
8888
8888
88
CAL

Extech Instruments EA80 Specifications

General

Brand	Extech Instruments
Model	EA80
Category	Measuring Instruments
Language	English