EC400-en-GB_V2.7 12/16
10
Maintenance
Battery Replacement
1. Twist off the battery compartment cap.
2. Holding the battery housing in place with a finger, pull out the battery carrier using the two
small tabs.
3. Replace the four (4) CR2032 batteries observing polarity.
4. Replace the battery compartment cap
Never dispose of used batteries or rechargeable batteries in household waste.
As consumers, users are legally required to take used batteries to appropriate collection
sites, the retail store where the batteries were purchased, or wherever batteries are sold.
Disposal:
Do not dispose of this instrument in household waste. The user is obligated to
take end-of-life devices to a designated collection point for the disposal of electrical and
electronic equipment.
Electrode Replacement
1. To remove an electrode, unscrew and completely remove the electrode collar (turn the collar
counter-clockwise to remove).
2. Gently rock the electrode from side to side, pulling it downwards, until it disconnects from the
meter.
3. To attach an electrode, carefully plug the electrode into the meter socket (note that the
electrode connector is keyed, ensuring proper connection).
4. Tighten the electrode collar firmly enough to make a good seal (a rubber gasket seals the
electrode with the meter).
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
