Extech Instruments MiniTec MN36 User Manual

MN35-EU-EN V2.3 4/13
2
Introduction
CongratulationsonyourpurchaseofExtech’sMN35ManualRangingMultimeter.Thismeter
measuresAC/DCVoltage,DCCurrent,Resistance,Temperature,BatteryTest,DiodeTestand
Continuity.Thismeterisshippedfullytestedandcalibratedand,withproperuse,willprovide
yearsofreliableservice.Pleasevisitourwebsite(www.extech.com)tocheckforthelatestversion
ofthisUserGuide,ProductUpdates,andCustomerSupport.

Safety
InternationalSafetySymbols
Thissymbol,adjacenttoanothersymbolorterminal,indicatestheusermustrefertothe
manualforfurtherinformation.


Thissymbol,adjacenttoaterminal,indicatesthat,undernormaluse,hazardousvoltages
maybepresent


Doubleinsulation

SafetyPrecautions
1. Improperuseofthismetercancausedamage,shock,injuryordeath.Readandunderstandthis
usermanualbeforeoperatingthemeter.
2. Makesureanycoversorbatterydoorsareproperlyclosedandured.
3. Alwaysremovethetestleadsbeforereplacingthebatteryorfuses.
4. Inspectthe
conditionofthetestleadsandthemeteritselfforanydamagebeforeoperatingthe
meter.Repairanydamagebeforeuse.
5. Donotexceedthemaximumratedinputlimits.
6. Usegreatcarewhenmakingmeasurementsifthevoltagesaregreaterthan25VACrmsor
35VDC.Thesevoltagesare
consideredashockhazard.
7. Alwaysdischargecapacitorsandremovepowerfromthedeviceundertestbeforeperforming
Diode,ResistanceorContinuitytests.
8. Removethebatteryfromthemeterifthemeteristobestoredforlongperiods.
9. Toavoidelectricshock,donotmeasureACcurrentof
anykind
InputLimits
Function MaximumInput
VDC,VAC 600VDC/AC
Resistance,Diode,Continuity 500VDC/AC
mADC 250mADC
10ADC 10ADC(15sec.maxevery15min.)

www. .com
information@itm.com1.800.561.8187

Extech Instruments MiniTec MN36 Specifications

General

Brand	Extech Instruments
Model	MiniTec MN36
Category	Multimeter
Language	English