Extech Instruments MiniTec MN36 User Manual

MN35-EU-EN V2.3 4/13
6
BatteryReplacement
WARNING:Toavoidelectricshock,disconnectthetestleadsfromanysourceofvoltage
beforeremovingthebattery/fusecover.
1. Disconnectthetestleadsfromthemeter.
2. Removetherubberholster(ifinplace).
3. RemovethetwoscrewssecuringtherearcoverusingaPhillipsheadscrewdriver.
4. Liftthecoveroffandreplacethebatteryobservingthecorrectpolarity.
5. Insertthenewbatteryintothebattery
holder.
6. Replacetherearcoverandsecurewiththescrews.

Neverdisposeofusedbatteriesorrechargeablebatteriesinhouseholdwaste.
Asconsumers,usersarelegallyrequiredtotakeusedbatteriestoappropriate
collectionsites,theretailstorewherethebatterieswerepurchased,orwherever
batteriesaresold.
Disposal:
Donotdisposeofthisinstrumentinhouseholdwaste.Theuseris
obligatedtotakeend‐of‐lifedevicestoadesignatedcollectionpointforthedisposal
ofelectricalandelectronicequipment.

OtherBatterySafetyReminders
o Neverdisposeofbatteriesinafire.Batteriesmayexplodeorleak.
o
Nevermixbatterytypes.Alwaysinstallnewbatteriesofthesametype.
FuseReplacement
WARNING:Toavoidelectricshock,disconnectthetestleadsfromanysourceofvoltage
beforeremovingbattery/fusecover.
1. Disconnectthetestleadsfromanycircuitbeingmeasured.
2. Removetherubberholster(ifinplace).
3. RemovethetwoscrewssecuringtherearcoverusingaPhillipsheadscrewdriver.Removethe
rearcover.
4. Removetheoldfusebygentlypullinguponit.
5. Installthenewfusebygentlypushingitintotheholder.
6. Alwaysuseafuseofthepropersizeandvalue;250mA/250Vfastblow.
7. Replacetherearcoverandsecurewiththescrews.


www. .com
information@itm.com1.800.561.8187

Extech Instruments MiniTec MN36 Specifications

General

Brand	Extech Instruments
Model	MiniTec MN36
Category	Multimeter
Language	English