7
PRECAUTIONS AND SAFETY
Chapter 1
The stoves manufactured in our factory are built
with the maximum dedication to the individual
components so as to protect both the user and the
installer from accidents. Authorized personnel are
therefore advised to pay special attention to the
electrical connections after any servicing operation
on the product, especially with regard to the stripped
part of the wires, which must not protrude in any
way from the terminal block to prevent possible
contact with the live parts of the wire.
Installation must be carried out by authorized
personnel, who must issue the purchaser a
declaration of compliance of the system. The
purchaser shall assume responsibility for the
definitive installation and consequent proper
operation of the product installed. It is imperative
to consider all national, regional, provincial and
communal laws and norms in the country where
the stove is installed. Extraflame S.p.A. may not
be held responsible in the event of failure to
observe these precautions.
This instruction manual constitutes an integral
part of the product. It must always accompany the
appliance, also when it is transferred to another
owner or user or moved to another location. If the
manual gets damaged or lost, ask your local service
centre for another copy.
This stove must only be used for the applications for
which it was expressly designed.
The manufacturer declines any responsibility,
contractually or extra-contractually, for any damage
caused to persons, animals or property by errors in
installation, adjustment, and maintenance, or by
improper use.
After removing the packaging, check to make sure
that the contents are intact and complete.
If this is not the case, contact the vendor from whom
the appliance was purchased.
The electrical components of the stove must only
be replaced with original spare by an authorized
service centre.
General stove maintenance must be carried out at
least once a year, scheduled su ciently in advance
with the service centre.
The following safety precautions must be
observed:
Do not allow the stove to be used by unattended
children or disabled persons.
Do not touch the stove if you are bare-footed
or if parts of your body are wet or damp.
Modifying the safety or adjustment devices
without the manufacturer’s approval or
instructions is forbidden.
Never pull, detach, or twist the electrical cables
coming out of the stove, even if it is disconnected
from the electrical power.
Do not plug or reduce the size of the air vents of
the room in which the stove is installed.
The air vents are critical for correct combustion.
Keep the packaging materials out of the reach
of children and unattended disabled persons.
During normal functioning of the product the
door of the furnace must always be closed.
Avoid direct contact with parts of the appliance,
which tend to heat up during functioning.
Check for the presence of any obstructions
before switching the appliance on following a
long standstill period.
The stove has been designed to function in any
climatic conditions (even critical), in particularly
adverse conditions (strong wind, freezing) safety
systems may intervene, which switch the stove
o .
If this happens, contact the after-sales service and
do not disable the safety systems in any case.
If the ue should catch re use adequate
systems to su ocate the ames or request help
from the re brigade.
PRECAUTIONS AND SAFETY
To Next Page
Loading...
Need help?
General
