30
Chapter 9
PRODUCT FUNCTIONING
CURRENT TIME AND DAY SETTINGS
Commands procedure
Switch the stove o and on again using the master switch on the back of the stove.1.
The following messages are shown: rst, the microchip version (2. EXTRA_43 or later), then “TIME”, “ LI 3”,
and “OFF”.
Press button 5 when “3. TIME” is being shown to enter the setting mode.
The day of the week (from DAY1 to DAY7) is shown on display D1.Enter the current day using buttons 2 4.
and 3 and con rm with button 5.
Display D1 Meaning
DAY 1 Monday
DAY 2 Tuesday
DAY 3 Wednesday
DAY 4 Thursday
DAY 5 Friday
DAY 6 Saturday
DAY 7 Sunday
On display D1, the hour is blinking, whereas the minutes are stable. Enter the current hour using buttons 5.
2 and 3. Con rm with button 5.
On display D1, the hours are now stable and the minutes are blinking. Enter the current minutes using 6.
buttons 2 and 3.
To go back to hour setting, press button 4; otherwise con rm and exit with button 1.
FUNCTIONING CYCLE
BASIC INSTRUCTIONS
The stove you have purchased uses pellets as fuel. This type of material is produced from natural waste from
woodworking. By means of a special process, which does not require the use of any binders or additives,
the shavings are compressed in industrial machines under high pressure and become solid wooden pellets.
IT IS STRICTLY FORBIDDEN to burn any other material besides pellets in our stove.
Failure to respect these instructions will void all warranties and may jeopardise the safety of the
appliance.
The rst two or three times the stove is lit, the following recommendations should be observed:
It is possible that slight odours are produced due to the drying of the paint and silicon used. Avoid
prolonged stay.
Do not touch the surfaces, as they could still be unstable.
Air the premises several times.
The hardening of the surfaces is completed after several heating processes.
This stove must not be used as a waste incinerator.