Figure 16: Separating the Inner Sliding Rails
2. Attach the outer rail (bracket) to the rack, securing it with the M5 screws.
Figure 17: Attaching the Outer Rail
3. Attach an inner rail to the side of the device, using the M4 screws.
• If you are using the 1U long rack ears (already attached to the inner rail): Ensure
that the rack ear is ush with the either the front or the rear panel of the unit and
continue to step 4 on page 57.
Install the Switch Four-Post Rack Mount
Extreme 7720 Hardware Installation Guide 55
To Next Page
Loading...
