Extreme Networks 7720 - Two-Post Rack Mounting

Figure 22: Rear Installation: Inserting the Device
Secure the device to the rack using the thumb screws on the mounting ears.
Figure 23: Secure the Device
Two-Post Rack Mount
You can attach the switch to a two-post rack in either of two congurations:
• Front mount
• Mid-mount
The side of the switch has different sets of holes for attaching mounting brackets in
either conguration.
Brackets for a two-post mount are not included in the box with the switch. However,
they can be ordered separately using part number XN-2P-RKMT299.
To attach the switch to a two-post rack, follow these steps:
1. On one side of the switch, attach one of the short mounting brackets to the device.
a. For a front mount, position the bracket over the holes so that the ange (ear) is
even with the front of the device, as shown in the gure below:
Two-Post Rack Mount Install the Switch
58 Extreme 7720 Hardware Installation Guide