Figure 24: Attaching a Short Mounting Bracket (Ear): Front of Switch
b. For a mid-mount, position the bracket so that the ange (ear) is positioned
slightly more than halfway between the front and back of the device, as shown in
gure below:
Figure 25: Attaching a Short Mounting Bracket (Ear): Middle of Switch
c. Use four small mounting screws (provided) to attach the bracket to the device.
2. Attach the other short mounting bracket to the other side of the device, as you did
in step 2.
3. Secure the brackets to the rack posts using rack-mounting screws that are
appropriate for the rack (not provided).
If the switch comes with installed power supplies, skip to the topic: Turn on the Switch
on page 61.
If the switch does not have an installed power supply, install one or two power supplies
using the instructions in Install Internal Power Supplies on page 60.
Install the Switch Two-Post Rack Mount
Extreme 7720 Hardware Installation Guide 59
To Next Page
Loading...
