Figure 27: Installing an 800 W AC Power Supply
7. Push the power supply in until the latch snaps into place.
Do not slam the power supply into the switch.
Note
If power supplies are not installed in both power supply bays, be sure to
install a cover over the unoccupied bay. Unoccupied bays must always be
covered to maintain proper system ventilation and EMI levels.
8. Connect the power cord to the power supply and to a grounded AC power outlet.
Warning
Always make sure that the source outlet is properly grounded before
plugging the AC power cord into the AC power supply.
9. If the power supply is equipped with a power cord retainer, use the retainer to
secure the power cord to the power supply.
Remove and Replace Components Replace an 800 W Internal AC Power Supply
Extreme 7720 Hardware Installation Guide 69
To Next Page
Loading...
