Regulatory Information
AP-7622 Access Point Installation Guide 24
• If you have any reason to suspect that interference is taking place, turn OFF your device.
Other Medical Devices
Please consult your physician or the manufacturer of the medical device to determine if the
operation of your wireless product may interfere with the medical device.
RF Exposure Guidelines
Safety Information
Reducing RF Exposure - Use Properly
Only operate the device in accordance with the instructions supplied.
International
The device complies with internationally recognized standards covering human exposure to
electromagnetic fields from radio devices.
Access Points
Access Points must conform to U.S. Federal Communications Commission's (FCC)
limitations. FCC has now stipulated a 21dBm EIRP limit for power directed 30 degrees
above the horizon.
For supplied antennas, compatible with 5.0 GHz on the access points, refer to the Antenna
Guide for "Elevation Gain" information. If using a third-party antenna, it is required that you
obtain the antenna-elevation gain information from the antenna manufacturer.
Panel antennas and polarized antennas for point to point only are excluded from this
requirement.
The elevation gain must be configured if the access point:
• Is used with dipole antenna. and
• Is transmitting in the 5.15 - 5.25 GHz Unlicensed National Information Infrastructure-1
(UNII1) band
Power Supply
Use ONLY an approved UL LISTED ITE (IEC/EN 60950-1, LPS/SELV) power supply with
electrical ratings: Output 12Vdc, min 1A, with a maximum ambient temperature of at least
50 degrees C. Use of alternative power supply will invalidate any approvals given to this
unit and may be dangerous.
Alternately this device may be powered from a 802.3af compliant power source which has
been certified by the appropriate agencies, or by an approved UL LISTED ITE (IEC/EN
60950-1, LPS/SELV) power supply with electrical ratings: Output 48Vdc, min 0.25A, with a
To Next Page
Loading...
Need help?
General
