3AP-7622 Access Point Installation Guide
1
Introduction
The Access Point’s unique WiNG 5 software enables the Access Point to function as either a
Standalone Access Point, an Adaptive Access Point or a Virtual Controller.
If new to Access Point technology, refer to the WiNG Access Point System Reference Guide
to familiarize yourself with the feature set supported by the WiNG operating system.
This document is written for the qualified network device installer.
Warnings
• Read all installation instructions and site survey reports, and verify correct equipment
installation before connecting the Wireless Wallplate.
• Remove jewelry and watches before installing this equipment.
• Verify any device connected to this unit is properly wired and grounded.
• Verify there is adequate ventilation around the device, and that ambient temperatures
meet equipment operation specifications.
Site Preparation
• Consult your site survey and network analysis reports to determine specific equipment
placement, power drops, and so on.
• Assign installation responsibility to the appropriate personnel.
• Identify and document where all installed components are located.
• Ensure adequate, dust-free ventilation to all installed equipment.
• Identify and prepare Ethernet connections.
• Verify cable lengths are within the maximum allowable distances for optimal signal
transmission.
AP-7622 Package Contents
An AP-7622 Access Point is available in internal antenna (AP-7622) configurations. An AP-
7622 ships with the following:
•AP-7622 Access Point
• AP-7622 Quick Install Guide
Features
An AP-7622 Access Point supports the following feature set:
•One RJ-45 connector (GE1)
•One RJ-45 console port (Console)
• Three LED indicators (2.4GHz, 5GHZ and BLE)
To Next Page
Loading...
Need help?
General
