Extreme Networks Extreme 7520 Series - Remove the Switch from a Two-Post Rack

Figure 31: Removing the Slider Assembly: Rear Rack Post
e. Release the tab that holds the front of the slider assembly to the front rack post,
and pull the pegs out.
Figure 32: Removing the Slider Assembly: Front Rack Post
f. Repeat step 3.d and step 3.e to remove the second slider assembly.
Remove the Switch from a Two-Post Rack
To remove a device from a two-post rack, do the following:
1. Unscrew the mounting brackets from the rack while carefully supporting the weight
of the device.
2. Tilt the device so that the brackets are clear of the rack posts, and carefully lift it out
of the rack.
Remove the Switch from a Two-Post Rack Remove and Replace Components
76 Extreme 7520 Hardware Installation Guide