Figure 29: Attaching a Mounting Bracket (Ear): Front of Switch
b. To install the switch in the rear of the rack, attach a mounting ear to the chassis, using #6-32
screws, so that the mounting ear is flush with the rear of the rack.
Figure 30: Attaching a Mounting Bracket (Ear): Rear of Switch
5. Repeat steps 2 on page 57 through 4 for the other side of the switch.
6. Insert the switch into the rail kit. To install the switch in the front of the rack, slide the switch into the
outer rails in the front of the rack.
Install Your Switch
Four-Post Rack Mount
ExtremeSwitching 5720 Series Hardware Installation Guide 59
To Next Page
Loading...