Extreme Networks ExtremeSwitching 5720 Series - Replace a Versatile Interface Module or Solid-State Drive

Replace a Versatile Interface Module or Solid-
State Drive
This section describes how to replace versatile interface modules (VIMs) or an SSD in the rear slot of an
5720 Series switch.
You need the following tools and materials to install a VIM:
• ESD-preventive wrist strap
• #2 Phillips screwdriver
Caution
VIMs and SSDs are not hot-swappable. Disconnect power to the switch before removing
an installed a VIM or SSD, or installing a new one.
To replace a VIM or SSD:
1. Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2. Disconnect the switch power.
3. Remove the existing VIM or SSD:
a. Remove the retaining screws holding the existing module in place.
Figure 52: SSD Module Inserted in Slot
ExtremeSwitching 5720 Series Hardware Installation Guide
85