Figure 39: Two-Post Mid-Mount: Complete
7. Verify that the switch is level and is firmly attached to the rack.
If your switch comes with installed AC power supplies, skip to the topic Turn on the Switch on page 67.
If your switch does not have an installed power supply, install one or two power supplies using the
instructions in Replace Internal AC Power Supplies on page 75.
Install Optional Components
After the switch is secured to the rack, install optional components.
ExtremeSwitching switches support the use of pluggable transceivers and cables in the SFP+, SFP28,
QSFP+, and QSFP28 formats.
For a list of the optical components supported with ExtremeSwitching devices, see the Extreme Optics
website.
Install Your Switch
Install Optional Components
ExtremeSwitching 5720 Series Hardware Installation Guide 65
To Next Page
Loading...