Figure 40: Removing a slot Cover Plate (VIM slot cover shown)
1 = VIM module retaining screw locations
b. Remove the cover plate from the VIM slot.
3. Remove the new VIM from its anti-static packaging.
4. Install the VIM in the switch:
a. Carefully slide the VIM module into the switch.
b. Insert and tighten the retaining screws you previously removed, using the screws provided.
Figure 41: VIM Module Inserted in Slot
1 = VIM module retaining screw locations
Install an SSD Module
This topic describes how to install a Solid-State Drive (SSD) module in the rear slot of the 24MXW and
48MXW switch models.
You need the following tools and materials to install an SSD module:
• ESD-preventive wrist strap
Install Expansion Modules
Install an SSD Module
ExtremeSwitching 5720 Series Hardware Installation Guide 73
To Next Page
Loading...