• #2 Phillips screwdriver
Warning
To prevent damage to the switch or SSD module, the switch must be powered OFF when
removing or installing SSD modules. SSD modules are not hot-swappable.
1. Attach the ESD wrist strap to your wrist and connect the metal end to an appropriate ground point
on the rack.
2. Ensure that the switch is completely powered down.
3. Remove the rear panel blank from the SSD slot (#2 Phillips screwdriver required) in the rear of the
switch.
Figure 42: SSD Rear Panel Blank
1 = SSD blank retaining screw location
4. Remove the SSD module from its packaging.
5. Carefully slide the SSD module into the slot on the rear panel until it is firmly in place.
6. Secure the SSD module using the screw provided.
Figure 43: SSD Module Inserted in Slot
1 = SSD module retaining screw location
Install an SSD Module Install Expansion Modules
74 ExtremeSwitching 5720 Series Hardware Installation Guide
To Next Page
Loading...