Figure 53: VIM Module Inserted in Slot
b. Save the retaining screws to secure the new module in the switch.
c. Pull the old module out of the module slot.
4. Remove the new VIM or SSD module from its anti-static packaging.
5. Install the VIM or SSD in the switch:
a. Carefully slide the module into the switch.
b. Insert and tighten the retaining screws you removed in step 3.a.
Figure 54: Tighten Screws to Secure the VIM Module
Figure 55: Tighten Screw to Secure the SSD Module
Replace a Versatile Interface Module or Solid-State
Drive
86 ExtremeSwitching 5720 Series Hardware Installation Guide
To Next Page
Loading...