Install the Access Point
AP310i/e Box Contents on page 13
Access Point Installation Options and Accessory Information on page 14
Install the Access Point on Drywall or Wood Wall, or to a Solid Flat Ceiling
on page 15
Install the Access Point on a Suspended Ceiling or a Drop Ceiling with a Flat T-
bar on page 21
Install the Access Point on a Junction Box or Gang Box on page 28
Install the Access Point on a Beam on page 28
About This Task
The access point is installed on flat surfaces such as drywall or wood wall, solid flat ceiling, suspended
or drop ceiling with T-bar, to beams, or to a junction or gang box. Optional adapters and brackets are
available for mounting the access point to non-flat ceiling tiles and T-bars.
See purchase order information for details on access points and optional brackets part numbers.
Before installing the access point:
Procedure
1. Verify the box contents.
2. Visually inspect the access point, the bracket, and any other optional accessories you have ordered
for physical damage.
If there is any damage, contact Extreme Networks Support.
3. Read and review the safety guidelines.
AP310i/e Box Contents
When you purchase the AP310i or AP310e access point, ensure that the following items are available in
the box:
• An AP310i/e Quick Reference
• One access point (AP310i or AP310e)
• A stainless-steel mounting bracket for 802.11ax indoor access point
ExtremeWireless™ AP310i/e Access Points 13
To Next Page
Loading...
Need help?
General
