Install the Access Point
Access Point and Accessory Box Contents and Order Information on page 15
Access Point Mounting Options and Accessory Usage on page 17
Install the Access Point on a Vertical Pole or a Horizontal Pole on page 17
Install the Access Point on a Flat Surface on page 20
About This Task
The access point can be installed on an outdoor environment on a vertical or horizontal pole, or to a flat
surface. For more information about selecting the right access point for your installation needs, see
Access Point and Accessory Box Contents and Order Information on page 15.
Note
The installation procedure for AP460C, AP460S6C, and AP460S12C access points are similar.
The installation procedures covered in this document is applicable to all these access points.
Procedure
1. Verify the box contents.
2. Visually inspect the access point, the bracket, and any other optional accessories you have ordered
for physical damage.
If there is any damage, contact Extreme Networks Support.
3. Read and review the safety guidelines.
Tip
For best performance, deploy devices in open areas at least 100.0 ft. (30.5 m) apart from
each other.
Access Point and Accessory Box Contents and Order Information
Access point box contents
When you purchase the access point, ensure that the following items are available in the box:
• An access point you have ordered (AP460C, or AP460S6C, or AP460S12C) with two installed M20
cable gland assemblies and plugs, and two installed M25 seal caps
• Hardware bag containing grounding hardware:
◦ M4 ground screw
ExtremeWireless™ AP460C, AP460S6C, and AP460S12C Access Points
15
To Next Page
Loading...
Need help?
General
