164 Summit 200 Series Switch Installation and User Guide
Status Monitoring and Statistics
Logging Commands
Use the commands described in Table 48 to configure or reset logging options, or to display or clear the
log.
Table 48: Logging Commands
Command Description
clear counters Clears all switch statistics and port counters.
clear log {static} Clears the log. If static is specified, the
critical log messages are also cleared.
config log display {<priority>} Configures the real-time log display. Specify
the priority option to filter the log to display
messages with the selected priority or higher
(more critical). Priorities include critical,
emergency, error, alert, warning, notice, info,
and debug. If not specified, informational
priority messages and higher are displayed.
config syslog {add} <host name/ip> <facility>
{<priority>}
Configures the syslog host address and filters
messages sent to the syslog host. Up to 4
syslog servers can be configured. Options
include:
• host name/ip—The IP address or name
of the syslog host.
• facility—The syslog facility level for
local use (local0 - local7).
• priority—Filters the log to display
messages with the selected priority or
higher (more critical). Priorities include
critical, emergency, alert, error, warning,
notice, info, and debug. If not specified, only
critical priority messages and are sent to the
syslog host.
config syslog delete <host name/ip> <facility>
{<priority>
Deletes a syslog host address.
• facility—The syslog facility level for
local use (local0 - local7).
• priority—Filters the log to display
messages with the selected priority or
higher (more critical). Priorities include
critical, emergency, alert, error, warning,
notice, info, and debug. If not specified, only
critical priority messages and are sent to the
syslog host.
disable cli-config-logging Disables configuration logging.
disable log display Disables the log display.
disable syslog Disables logging to a remote syslog host.
enable cli-config-logging Enables the logging of CLI configuration
commands to the Syslog for auditing purposes.
The default setting is enabled.
enable log display Enables the log display.
enable syslog Enables logging to a remote syslog host.
To Next Page
Loading...
