RMON
Summit 200 Series Switch Installation and User Guide 167
By default, RMON is disabled. However, even in the disabled state, the switch response to RMON
queries and sets for alarms and events. By enabling RMON, the switch begins the processes necessary
for collecting switch statistics.
Event Actions
The actions that you can define for each alarm are shown in Table 49.
To be notified of events using SNMP traps, you must configure one or more trap receivers, as described
in Chapter 5, “Managing the Switch”.
Table 49: Event Actions
Action High Threshold
No action
Notify only Send trap to all trap receivers.
Notify and log Send trap; place entry in RMON log.
To Next Page
Loading...
