Extreme Networks Summit 200-24 - UDP-Forwarding Commands

192 Summit 200 Series Switch Installation and User Guide
IP Unicast Routing
UDP-Forwarding Commands
Table 58 describes the commands used to configure UDP-forwarding.
Table 58: UDP-Forwarding Commands
Command Description
config udp-profile <profile_name> add <udp_port>
[vlan <name> | ipaddress <dest_ipaddress>]
Adds a forwarding entry to the specified
UDP-forwarding profile name. All
broadcast packets sent to <udp_port>
are forwarded to either the destination IP
address (unicast or subnet directed
broadcast) or to the specified VLAN as an
all-ones broadcast.
config udp-profile <profile_name> delete
<udp_port> [vlan <name> | ipaddress
<dest_ipaddress>]
Deletes a forwarding entry from the
specified udp-profile name.
config vlan <name> udp-profile <profile_name> Assigns a UDP-forwarding profile to the
source VLAN. Once the UDP profile is
associated with the VLAN, the switch picks
up any broadcast UDP packets that
matches with the user configured UDP
port number, and forwards those packets
to the user-defined destination. If the UDP
port is the DHCP/BOOTP port number,
appropriate DHCP/BOOTP proxy functions
are invoked.
create udp-profile <profile_name> Creates a UDP-forwarding profile. You
must use a unique name for the
UDP-forwarding profile.
delete udp-profile <profile_name> Deletes a UDP-forwarding profile.
show udp-profile {<profile_name>} Displays the profile names, input rules of
UDP port, destination IP address, or VLAN
and the source VLANs to which the profile
is applied.
unconfig udp-profile vlan [<name> | all] Removes the UDP-forwarding profile
configuration for one or all VLANs.