DRM – Dynamic Radio Management
Summit WM Technical Reference Guide, Software Version 5.1142
6 Click Save.
7 Wait a few minutes until the system stabilizes, and then verify if the selected Tx power is adequate
by doing one of the following (or both):
● Perform a quick site survey (just test a few points) to verify that the coverage is adequate.
● Compare the Tx Power in the Active Altitude APs display with the Tx Power recommended
during the site survey
8 Perform any adjustments as required:
● If the Tx power for a Wireless AP must be raised, increase the Auto Tx Power Ctrl Adjust setting.
NOTE
If the Tx power reaches its maximum, further increasing the Auto Tx Power Ctrl Adjust setting will have no
effect. This may be a sign that the Tx power must be increased on other Wireless APs or that a new Wireless AP
has to be added to the network.
To Next Page
Loading...
