Summit WM Controller diagnostics
Summit WM Technical Reference Guide, Software Version 5.166
Table 13 shows the system capacities for each license.
Summit WM Controller WM200/2000 LEDs
The SME is the main entity in charge of system monitoring and state reporting. The LED states for the
card represent the system states.
Figure 7: System LED diagram
The reported states for the Summit WM Controller WM200/2000 are:
● Run LED – This indicator indicates CPU activity. Once CPU initialization is complete, the Run LED
blinks with CPU activity.
● Activity LED – This indicator will be turned on upon application (SMT) start. It indicates that the
system in now under application control. It also indicates health monitor for app/system
initialization and provides a reset context for error codes.
● Warning/Error LED – The Yellow (Warning) and Red (Error) indicators are ALARM LEDs signalling
a problem state. These LEDs are used by the application to indicate the running state of the system.
The corresponding error code is displayed in the SSD and a corresponding error alert is provided in
through the Log system.
The Seven-Segment Display (SSD) is used to provide information about startup or processor load.
Table 13: Summit WM Controller WM200/2000 system capacity
WM200 WM2000
Number of APs
100 (50 as shipped with base license;
50 with capacity upgrade license)
200 (100 as shipped with base
license; 100 with capacity upgrade
license)
Number of Users
2048 4096
Number of WM-Access Domains
32 64
Number of Voice calls
200 500
Maximum Throughput
2Gbps 2Gbps
Part Number
15955: Controller with base license 15956 – Controller with base license
Reset
switch
WARNING
LED
ERROR
LED
INT LED
LCT switch
RUN
LED
ACT LED
Seven-segment
display
To Next Page
Loading...
