Summit WM Technical Reference Guide, Software Version 5.1 15
NOTE
The maximum number of simultaneous transmissions per radio (TKIP) limits are version dependent as follows:
• V1.x – Maximum 16 TKIP clients, maximum 112 WEP/AES/none
• V4.x/V5R1– Maximum 24 TKIP clients, maximum 112 WEP/AES/none
Feature capacities
Mobility
Availability
Max voice calls per radio Wireless to Wired WL2 11b/g = 8;
Spectralink 11b/g = 12
WL2 11b/g = 8;
Spectralink 11b/g = 12
Table 4: Mobility capacities
Limit Value Comments
Max. # of Summit
WM Controllers per
mobility domain
12 (1 Manager + 11 Agents) Mobility domains can consist of WM100/WM1000/
WM20/WM200/2000 platforms.
Max. # of systems
roamed
4096 – WM1000/WM2000
2048 – WM100/WM200
Each respective platform can accept only an equal
amount of users equivalent to its local capacity.
Max. # of
aggregated mobility
bandwidth
1Gbps – WM1000, WM200/
2000
100 Mpbs – WM100
200 Mbps - WM20
The maximum aggregated bandwidth is dependent
on the bandwidth of the physical interface on which
the inter-controller tunnel link is being established.
Note: In most cases the interface bandwidth is being
shared with other system operations (such as AP
tunnelling aggregation).
Table 5: Availability capacities
Limit Values Platforms
Max # systems per
availability cluster
2 Availability feature is supported in paired mode.
Max # APs per failover 200 WM1000/WM2000
Note:Failover limit is limited by the capacity of the
controller category in question
100 WM200
75 WM100
32 WM20
Failover time 200 APs – 1 Minute WM1000/WM2000
Table 3: Altitude Access Point system capacities (Continued)
Limit 450/451 350-2i/350-2d
To Next Page
Loading...
