Configuration of Dynamic Host Configuration Protocol (DHCP)
Summit WM Technical Reference Guide, Software Version 5.124
host all DHCP requirements for this network. It is possible to configure each WM-AD to use DHCP
relay to the example DHCP server of 10.0.0.9.
The following is the configuration file dhcpd.conf from the Linux server at 10.0.0.9:
Figure 4: dhcpd.conf example listing
This file can be divided into the following four areas:
● General options: lines 1-3
● Scope for 10.0.0.0/24 subnet: lines 4-8
● Scope for 172.16.1.0/24 subnet (voice subnet): lines 9-18
● Scope for 172.16.2.0/24 subnet (laptop subnet): lines 19-27
To Next Page
Loading...
