Extron electronics IPCP Pro Series - Cabling and Features

8
IPCP Pro Series • Setup Guide (Continued)
Cabling and Features
Attach cables using the following wiring diagrams as a guide. Full details are available in the IPCPPro Series User Guide.
ATTENTION:
• Installation and service must be performed by experienced personnel.
• L’installation et l’entretien doivent être effectués par du personnel expérimenté.
Power Input — External
POWER
12V
x.xA MAX
R
Ground all devices.
External
12 VDC
Power Supply
+12 VDC input
– Return
Ridged
Smooth
To
AC
power
Front Panel
Power Input, External Power Supply
• Front panel LED ( ) blinks during
boot-up and remains lit when the
IPCP is powered and operational.
• Connect to
included 12 VDC
power supply.
NOTE: Check the polarity of the power
supply before connecting it to the IPCP.
Ridged
Smooth
Tie Wrap
3/16"
(5 mm)
Max.
Power Input — Internal
R
1.2A MAX
100-240V 50-60Hz
Power Input, Internal Power Supply
• Front panel LED ( ) blinks
during boot-up and remains lit
when the IPCP receives power.
• Connect to 100 to
240 VAC.
Rear
Panel
Front Panel
Power Output — Switched 12 VDC Power Output
21 LIMIT
SWITCHED
12 VDC
OVER 43
12 VDC
SWITCHED 12 VDC
40W MAX TOTAL
3 4
1 2
Lights if total power drawn
is 41-46 watts.
Lights if total power drawn
exceeds 47 watts.
Power output shuts off
until the user corrects the
overload.
Switched 12 VDC
Power Output
• Total output for all four ports
combined:
12 VDC, 40 watts (max.)
• Corresponding front panel
green LEDs ( ) light when
power is available at each port.
3/16"
(5 mm)
Max.
Rear
Panel
Front
Panel
Tie Wrap
Power Output — PoE+
The IPCPPro360 can output PoE+ on AV LAN ports 2 and 3. For details, see the PoE+ output information on page 11.
ATTENTION:
• Always use a power
supply supplied or
specified by Extron. Use
of an unauthorized power
supply voids all regulatory
compliance certification and
may cause damage to the
supply and the unit.
• Utilisez toujours une source
d’alimentation fournie par
Extron. L’utilisation d’une
source d’alimentation non
autorisée annule toute
certification de conformité
réglementaire et peut
endommager la source
d’alimentation que l’unité.
Rev. E: replaced
isometric power
supply with
orthogonal version.
Updated French
translation of 2nd
paragraph.