Extron electronics XTP II CrossPoint 1600 Setup Guide

39XTP II CrossPoint Series • Remote Control
SIS Command and Response Table for Receiver Endpoints
NOTE: These commands allow you to control and monitor the HDMI receiver endpoint from the matrix switcher.
Command SIS Command
(Host to Unit to Endpoint)
Response (Endpoint to Unit to Host)
Additional Description
HDCP status
View output HDCP status
E
O
X@
HDCP
} X(]
View HDCP status of all outputs
E
O*HDCP
} X(
1
X(
2
X(
3
...
X(
n
]
Video mutes
Video mute
X@
*1B Vmt
X@
*1
]
Mute output
X@
(video off).
Video unmute
X@
*0B Vmt
X@
*0
]
Unmute output
X@
(video on).
Read video mute
X@
B
X1)]
1 = mute on, 0 = mute off.
Global video mute
1*B
Vmt1
]
Mute all video outputs.
Global video unmute
0*B
Vmt0
]
Unmute all video outputs.
Audio output volume
Set the volume to a specic value
X@
*
X1%
V Out
X@
•Vol
X1%]
Example:
1*50v
Out01•Vol50
]
Set output 1 volume to 79%.
Increment volume
X@
+V Out
X@
•Vol
X1%]
Increase volume by 1 step.
Example:
1+V
Out01•Vol51
]
Decrement volume
X@
–V Out
X@
•Vol
X1%]
Decrease volume by 1 step.
Read output volume
X@
V
X1%]
NOTE: • = Space
X@
= Output number 01 – 16, 32, or 64
X1)
= Mute 0 = off (unmuted) 1 = on (muted)
X1%
= Volume adjustment range 0 – 64 (1 dB/step except for 0-to-1, which is 22 dB) (default = 64 [0 dB])
X(
= HDCP status (for outputs) 0, 2, 4, or 6 = No monitor connected
1, 3, or 5 = Monitor connected but not encrypted 7 = Monitor connected and encrypted

Extron electronics XTP II CrossPoint 1600 Specifications

General

Brand	Extron electronics
Model	XTP II CrossPoint 1600
Category	Matrix Switcher
Language	English