Extron electronics XTP II CrossPoint 1600 - Arrangement of Command and Response Tables; SIS Command and Response Table for Matrix Switcher Commands; SIS Command and Response Table for Transmitter Endpoints; SIS Command and Response Table for Receiver Endpoints

25XTP II CrossPoint Series • Remote Control
Arrangement of Command and Response Tables
The following pages present ve command and response tables,
each dening a subset of SIS commands and their responses, with
examples where appropriate. The following tables are presented:
• SIS Command and Response Table for Matrix Switcher
Commands, starting on the next page — SIS commands to
control and monitor the XTP II CrossPoint matrix switcher itself
and specic input and output boards.
• SIS Command and Response Table for Transmitter
Endpoints, starting on page 37 — SIS commands to
control and monitor XTP transmitter endpoints from the matrix
switcher.
• SIS Command and Response Table for Receiver Endpoints,
starting on page 39 — SIS commands to control and monitor
XTP receiver endpoints from the matrix switcher.
• SIS Command and Response Table for Switching
Transmitter Endpoint, starting on page 42 — SIS
commands to control and monitor the XTP T USW 103 and
XTP T USW 103 4K switcher endpoint from the matrix switcher.
• SIS Command and Response Table for IP-Specific
Commands, starting on page 45 — SIS commands to
control and monitor the IP interface of the XTP II CrossPoint
matrix switcher.