Extron electronics XTP II CrossPoint 1600 - Front Panel

18 XTP II CrossPoint Series • Installation
Remote port connector
RS-232 Function Pin Function
1
2
3
4
5
6
7
8
9
—
Tx
Rx
—
Gnd
—
—
—
—
Not used
Transmit
Receive
Not used
Ground
Not used
Not used
Not used
Not used
—
Tx–
Rx–
—
Gnd
—
Rx+
Tx+
—
Not used
Transmit (–)
Receive (–)
Not used
Ground
Not used
Receive (+)
Transmit (+)
Not used
RS-422
5
1
96
Figure 9. Remote RS-232/RS-422 Output Connector Wiring
Front Panel
AUDIO
VIDEO
I/O
CONTROL
ENTER PRESET
VIEW
ESC
XTP SERIES DIGITAL MAT RIX SWITCHER
CONFIG
PRIMARY 1 2
1 2
REDUNDANT
POWER
XTP II CROSSPOINT 1600
AABB
Figure 10. Front Panel Features
A
Configuration port — If desired, connect a control system or
computer to the front panel configuration port, a USB mini-B
port.
B
Primary and Redundant Power Supply LEDs —
NOTES:
• The XTP II CrossPoint 6400 and XTP II CrossPoint 3200
have four power supplies installed and indicated.
• The XTP II CrossPoint 1600 has two power supplies
installed and indicated in its standard conguration
(only two LEDs lit). It is available in a four-power-supply,
redundant power upgrade conguration, in which it
indicates all four supplies.
Green — Indicates that the associated power supply is
operating within normal tolerances.
Red — Indicates that the associated power supply is operating
outside the normal tolerances or has failed.