Ezviz DB2 Pro - Maintenance; Disassemble Doorbell; Charge Doorbell; Appendix (Optional)

10
Maintenance
1� Disassemble
1. Turn off the TamperNotication on the EZVIZ app.
2. Use the pin provided to press and hold the hole on the bottom of the doorbell, meanwhile push the doorbell upwards and
then take it off.
�
2� Charge
Connect the doorbell to power outlet via power adapter.
USB Cable
Power Outlet
• When charging, the doorbell will automatically turn on.
• If you use a 5V 2A adapter to charge the doorbell, it will take about 4.5 hours to fully charge.
• If the doorbell is installed outdoors, please use waterproof power cable to charge.
• When charging the doorbell, make sure the lens faces upward to aviod fraying the lens.
Appendix (Optional)
Replace the existing doorbell with the EZVIZ doorbell
If you have an existing doorbell system or have installed a mechanical or electronic chime, you can replace the existing doorbell
with the EZVIZ doorbell.
- Please ring the existing doorbell rst to make sure it’s working.
- Determine the mounting position of the doorbell, and check if you can reuse the existing holes on the wall.
• We recommend installing a new transformer to bring the output 16 to 24 volts.
• Please refer to Quick Start Guide of your chime or transformer for the chime or transformer installing details.